BlahBlahCafe - Jean-Michel Jarre forum

Hi,

I wanted to try to play Chronologie 2 on the original one and I noticed my Roland D50 is slighty detuned
Is it the case for yours (if you have one ?)

Regards,
Nicolas

check the transpose function [near volume and aftertouch sliders], check also the tune functions in lower and upper tone.

but if everything seems to be ok then you need to chceck bender. my was broken and sometimes it detuned some sounds or loops [for example in machine run... the upper tone was played proper but the lower slowly pitched down ]. if i'm right check bender then

Thx Radek
All sounds are detuned, the Key Transpose is sets to 0 and tune is set to 0 too
I'll try the bender

i'm almost sure that sth wrong is with your bender

It doesn't come from the bender

Check it, move it or sth... Open your synth, check cables etc

I don't understand, listen to it : it's horrible ! the organ sound is D50's and the string is Nostalgia VST (Eminent)
edit : when I move the bender, there is a detune but not the right note

hmmm just edit pitch and tune parameters in lower/upper tone

Try a re-init: Turn off, hold "Data transfer" and "0", turn on. But be careful, i´m sure this procedure will put your sounds into factory presets.

Stef

Yes, and I can't make a B-Dump
I'll try to modify the tune

detune effect appears only in this sound or in all sounds ??

I didn't try all but it seems to appear on all the sounds

Press tune/fonction and check the master tune. by default, the D50 is at 442 hz, but (not sure) i think it should be to 440 hz...

yes 440 kHz

Thanks a lot to you all !!
I'll try it tomorrow, thanks again !!!